MW13 Iodine Photometer MILWAUKEE

MW13 Iodine Photometer MILWAUKEE - Downloadable manual at the bottom of the page

For more general information regarding the operating system of a Photometer, visit the Photometer category

Features:

Range 0.0 to 12.5 ppm

Resolution 0.1 ppm

Accuracy ± 0.1 ppm ± 5% of the reading at 25 °C

Light source 525 nm Light Emitting Diode

Light detector Silicon photocell

Method Adaptation of standard methods for the examination of water and wastewater, 18th edition, DPD method. The reaction between iodine and the reagent causes a pink coloration in the sample. Environment 0 to 50 °C (32 to 122 °F) max. 95% RH without condensation

Temperature compensation Automatic between 10 and 40 °C / 50 to 104 °F

Battery type 1 x 1.5 V AAA

Automatic shutdown After 2 minutes of non-use.

Dimensions 81.5 x 61 x 37.5 mm (3.2 x 2.4 x 1.5 ") Weight 64 g (2.25 oz)

Instructions for use:

- Take 10 ml of water from your aquarium and place it in the vial

- Place the vial in the photometer and press the button to calibrate

- Remove the vial and pour in the contents of an entire sachet

- Replace the vial in the photometer

- Press the photometer button, a countdown will start, which corresponds to the mixing time of the product.

- Once the countdown is finished, the reading is done automatically on the photometer

(interference may occur if you perform different tests with the same vials, be sure to mix the product gently and do not leave fingerprints around the vial).

Refill: see below