MW14 Iron Photometer MILWAUKEE

MW14 Iron Photometer MILWAUKEE- Downloadable manual at the bottom of the page

For more general information about how a Photometer works, visit the Photometer category

FEATURES

Range 0.00 to 5.00 ppm

Resolution 0.01 ppm

Accuracy ± 0.04 ppm ± 2% of reading at 25 °C

EMC typical dev. ± 0.01 ppm

Light source 525 nm LED

Light detector Silicon photocell

Method Adaptation of EPA Phenanthroline Method 315B, for natural and treated waters. The reaction between iron and the reagent causes an orange coloration in the sample. Environment 0 to 50 °C (32 to 122 °F) max. 95% RH without condensation

Battery type 1 x 1.5V AAA

Auto-shut off After 3 minutes of non-use and 2 minutes after reading.

Dimensions 81.5 x 61 x 37.5 mm (3.2 x 2.4 x 1.5") Weight 64 g (2.25 oz)

Instructions for use:

- Take 10 ml of water from your aquarium and place it in the vial

- Place the vial in the photometer and press the button to calibrate

- Remove the vial and then pour in the entire contents of one sachet

- Replace the vial in the photometer

- Press the button on the photometer; a countdown will begin, corresponding to the mixing time of the product.

- Once the countdown is finished, the reading will automatically appear on the photometer

(interferences may occur if you perform different tests with the same vials, be sure to mix the product gently and not to leave fingerprints around the vial).

Refill see below